Screw-In Bases

The Screw-In Base is part of the Screw-In Pipe and Drape System.  This system was historically the main system used for Pipe and Drape, but in the last decade has taken a backseat to the popular Slip-Fit System.  There are still plenty of applications, though, where the Screw-In System is beneficial and recommended.  It’s known as the ‘Space Saver’ system and is recommended if storage space is a premium for you.  The bases feature dimpled corners, which allow them to be stacked vertically.  It’s recommended for more permanent Pipe and Drape set-ups and is easy to move and position because the upright and base create one secure piece.

The Screw-In System features a threaded pin which is riveted into the bottom of the Upright and screws into one of the two threaded holes on the base, creating one secure piece.  Uprights can be screwed into either of the two threaded holes for a tight and secure fit.  All of these bases come standard in a black, powder-coated finish with rounded edges.

Base Recommendations

• 11″ x 11″ for Screw-In Uprights up to 3′ (6lbs)
• 15″ x 15″ for Screw-In Uprights up to 8′ (10lbs)
• 18″ x 18″ for Screw-In Uprights up to 12′ (15lbs)
• 24″ x 24″ for Screw-In Uprights up to 14′ (26lbs)

Screw-In Pipe and Drape Bases made with four dimples at each corner for easy stacking and storage.

CALIFORNIA PROPOSITION 65 WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information: www.P65Warnings.ca.gov
Disclaimer: Pipe and Drape should never be used where tip-over could cause harm or damage. Base plates are made from steel and are an industrial product; proper care should be used when handling. Gloves are recommended.